AJAS Cover
Frequency: Continuous
ISSN: 1546-9239 (Print)
ISSN: 1554-3641 (Online)
Research Article Open Access

Improving the Quality of Ceramic and Cemented Carbide Cutting Inserts by Diamond Grinding

Tareq Ahmad Abu Shreehah1 and Rasheed Abdulateef Abdullah1
  • 1 Department of Mechanical Engineering, Al-Balqa’ Applied University, Jordan

Abstract

The machining of hardened steel and other difficult-to-cut materials require high quality and progressive cutting tools to meet the growing requirements for increasing productivity, improving tool life and quality of the cutting process. This study deals with an experimental investigation on the quality improvement by diamond grinding of ceramic and cemented carbide cutting inserts, comparing it with conventional batch produced types. It was found that under finish turning of hardened up to 61 HRC steel the ground cutting inserts improve the machined surface finish, reduce tool wear and breakage and subsequently extend the tool life.

American Journal of Applied Sciences
Volume 2 No. 5, 2005, 969-975

DOI: https://doi.org/10.3844/ajassp.2005.969.975

Submitted On: 23 February 2005 Published On: 31 May 2005

How to Cite: Abu Shreehah, T. A. & Abdullah, R. A. (2005). Improving the Quality of Ceramic and Cemented Carbide Cutting Inserts by Diamond Grinding. American Journal of Applied Sciences, 2(5), 969-975. https://doi.org/10.3844/ajassp.2005.969.975

Open AccessCopyright: © 2005 Tareq Ahmad Abu Shreehah and Rasheed Abdulateef Abdullah. This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.

  • 3,377 Views
  • 3,126 Downloads
  • 0 Citations

Download

Keywords

  • Finish Turning
  • Ceramic
  • Carbide
  • Tool Life
  • Surface Finish